VersaTraction Installation Procedure:

1. Thoroughly clean, removing all wax, dirt, oil and grease from surface area where you will be applying your VersaTraction products. For best results a pply a non-oil based solvent such as mineral spirts, paint thinner, or denatured alcohol to remove any residue. Repeat process if residue persists. Rub down with dry cloth and let dry completely. DO NOT USE SURF WAX REMOVER SOLVENTS THEY LEAVE A RESIDUE THAT DOES NOT ALLOW VT ADHESIVE TO STICK TO SURFBOARDS.

2. Unpeel the protective backing paper, exposing adhesive. Carefully place exposed adhesive edge to surface, and press down firmly.

3. Make sure that you try to eliminate as many air bubbles as possible by smoothing down product onto surface while applying.

4. Maximize traction by cleaning entire surface with Comet brand (non-abrasive cleanser) and water-using a soft scrub brush.