Installation

VersaTraction Kahuna Grip Installation Instructions

VersaTraction Kahuna Grip Installation, follow these instructions.

1. Thoroughly clean, removing all wax, dirt, oil and grease from surface area where you will be applying your VersaTraction products. For best results a pply a non-oil based solvent such as mineral spirts, paint thinner, or denatured alcohol to remove any residue. Repeat process if residue persists. Rub down with dry cloth and let dry completely. DO NOT USE SURF WAX REMOVER SOLVENTS THEY LEAVE A RESIDUE THAT DOES NOT ALLOW VT ADHESIVE TO STICK TO SURFBOARDS.

2. Unpeel the protective backing paper, exposing adhesive. Carefully place exposed adhesive edge to surface, and press down firmly.

3. Make sure that you try to eliminate as many air bubbles as possible by smoothing down product onto surface while applying.

4. Maximize traction by cleaning entire surface with Comet brand (non-abrasive cleanser) and water-using a soft scrub brush.

VersaTraction Kahuna Grip Installation but, if you have any question please contact us for more information.


VersaTraction Surf Traction Installation Instructions

VersaTraction Surf Installation Step 1

VersaTraction Step 1

With a clean towel/rag, clean surface removing all oil, dirt, wax, and grease. Then dry using towel/rag, make sure area has no residue present.

VersaTraction Surf Installation Step 2

VersaTraction Step 2

Peel back easy peel backing 1-2 inches down the stringer (straightest edge) side of the kit piece.

VersaTraction Surf Installation Step 3

VersaTraction Step 3

Place exposed adhesive side on surface press down in place. Note: easiest to work from center of board out towards rails.

VersaTraction Surf Installation Step 4

VersaTraction Step 4

Remove remaining easy peel backing while smoothing down traction from edge to edge until traction is secure on surface.


Kahuna Grip Installation Instructions

VersaTraction Surf Installation Step 4

Kahuna Grip Step 1

With a clean towel/rag, clean surface removing all oil, dirt, wax, and grease. Then dry using towel/rag, make sure area has no residue present.

VersaTraction Surf Installation Step 4

Kahuna Grip Step 2

Peel back “easy peel” backing and place exposed adhesive side on surface. Press down in place.

VersaTraction Surf Installation Step 4

Kahuna Grip Step 3

Remove remaining easy peel backing while smoothing down traction from edge to edge until traction is secure on surface.

VersaTraction/Kahuna Grip has unlimited uses and we make traction for many different types of needs. We have traction products for the following applications and more including, construction, home & bath, pool & spa, stairways, outdoors, marine, industrial, board sports, off-road, snowmobiles, watercraft, motorcycles, side by sides, and many others. If you need a custom traction solution please call us: 714-973-4589

VersaTraction, Inc.

Do You Have A Better VersaTraction Kahuna Grip Installation?

Tag us in your posts showing creative ways you use VersaTraction, VersaTraction on Instagram.